legend +25 oc +85 oc - - - - - - -55 oc power vdc +15 +15 ma 20 23 max. rf amplifier model TM7101PM available as: TM7101PM, 4 pin to-8 (t4) tn7101pm, 4 pin surface mount (sm3) bx7101pm, connectorized housing (h1) features low noise figure: 1.8 db typical high gain: 27.5 db typical operating temp. -55 oc to + 85 oc environmental screening available characteristic typical min/max ta= 25 oc ta = -55 oc to +85 oc frequency 10 - 150 mhz 10 - 150 mhz note: care should always be taken to effectively ground the case of each unit. noise figure (db) 1.8 2.5 max. vswr in <1.5:1 2.0:1 max. out <1.25:1 2.0:1 max. reverse isolation (db) -31.5 -30 max. power @ 1 db comp. (dbm) +16.5 +15.0 min. gain (db) 27.5 26.0 min. specifications typical performance data absolute maximum (no damage) ratings ambient operating temperature ................ -55oc to +100 oc storage temperature ................................. -62oc to +125 oc case temperature .................................................. +125 oc dc voltage .......................................................... +18 volts continuous rf input power .................................. +13 dbm short term rf input power ...... 50 milliwatts (1 minute max.) maximum peak power .................... 0.5 watt (3 sec max.) guaranteed @ 25 oc (80 mhz) phase noise performance (dbc/hz) * typical 100 hz 1 khz 10 khz 100 khz 1 mhz -164 -164 -164 -162 -155 -160 -160 -150 -155 -160 guaranteed typical intermodulation performance at 25 oc second order harmonic intercept point ....... +41 dbm (typ.) second order two tone intercept point ........ +35 dbm (typ.) third order two tone intercept point ............ +30 dbm (typ.) spectrum microwave 2144 franklin drive n.e. palm bay, florida 32905 ph (888) 553-7531 fax (888) 553-7532 spectrum microwave 2707 black lake place philadelphia, pennsylvania 19154 ph (215) 464-4000 fax (215) 464-4001 www.spectrummicrowave.com rev. 8/20/09 *note: phase noise performance typically tested at midband. bandedge performance may vary. frequency 2.0 1.5 1.0 2.0 1.5 1.0 1 3 2 29 27 25 +1 8 +1 7 +1 6 +1 5 +1 4 0 - 10 - 20 - 30 - 40 28 26 start 1 0 mh z st op 150 mh z st art 1 0 mh z st op 150 mh z sta rt 10 mhz st op 150 mh z start 10 mhz stop 150 mhz s t a r t 1 0 m h z s t o p 1 5 0 m h z start 10 mhz st op 150 mhz gain (db) 1 db comp. (dbm) input vswr reverse isolation (db) nois e f igure (db) output vswr 10 k 1k 100 k 10 0 1m -140 -150 -160 -170 -180 -130 __ __ __ __ typical -1 90 * residual phase noise test conditions carrier frequency: 80 mhz power o utpu t: +15 db m temperature: 25 oc agilent es5500 system phase noise (dbc/hz)
|
